The Cohhilition

Good day,

I received several PMs asking about the model I have been working on this week. (Thanks Cohh )

I am currently a 3D Game Artist Student, so I dont have much knowledge when it comes to 3D printing.

Images:

https://imgur.com/a/80f67Aq

Here is the file of my model. (nontextured)

http://www.mediafire.com/file/caedk0p8m ... Blade2.obj

Let me know if I have done it correctly.

See you in chat!

- Daanootje

Designed by a genius, forged by an idiot, the Dingus Keyblade falls into reality.

That came out nicely! @GuardEzio

The chain might be a little too small for a 3D printer.

A bit small and a bit fiddly for a 3D printer. It might be an idea to print the charm separately and then add it to the keyblade, by hand, with a fine chain.

The pipes that go up from the wings/hilt to the shaft could also do with being a bit thicker as the 3D printer can't do support for them - making them a bit hit and miss in the printing process (even if the wire-like effect is an interesting one).

For a rough prototype with no mesh (at least that's what the printing software was complaining about), however, it's come out very well. Now if only I had the skill to paint it up and leather grip the handle